Important Note: Wait for at least 72 hours before sealing a new floor or wall installation. Other installations, such as slab countertops can be sealed immediately after installation.

Directions: Test on a spare tile or inconspicuous area for desired results. The stone surface must be free of any coating, dust, soiling, etc. Start with an area approximately 3 to 4 square feet. Apply Impregnating Sealer with a soft white terry cloth. Apply sealer to cloth and spread evenly over the surface. DO NOT ALLOW TO PUDDLE OR SET ON SURFACE. Allow to penetrate for 45 minutes to 1 hour. To assure surface has been adequately sealed place a few drops of water on the stone. If the water beads, the stone is adequately sealed. If absorption occurs apply an additional application of sealer. Let cure for at least 3 to 4 hours prior to use. Impregnating Sealer may require more than one application on very porous marble, travertine, limestone, slate, and onyx surfaces.

CAUTION: Causes eye and skin irritation. Avoid contact with skin, eyes and clothes. In case of contact, flush thoroughly with water. If irritation persists, seek medical attention. Do not swallow. Keep out of reach of children.